Hip Raise (bent Knee)
The point of Hip Raise (bent Knee) is midsection control under load; pure bodyweight leverage is how it gets there.
How to do Hip Raise (bent Knee)
- Lie flat on your back with your knees bent and feet flat on the ground.
- Place your hands by your sides, palms facing down.
- Engage your core and glutes, then lift your hips off the ground until your body forms a straight line from your knees to your shoulders.
- Pause for a moment at the top, then slowly lower your hips back down to the starting position.
- Repeat for the desired number of repetitions.
Hip Raise (bent Knee) Sets and Reps by Goal
Strength
3 sets of 6-8 hard reps with 2 minutes of rest. Hold the end position for a beat once reps come easily.
Hypertrophy
3 sets of 10-15 reps with 60-90 seconds of rest. Add reps first, then slow the lowering phase.
Endurance
2-3 sets of 20-25 reps with 45 seconds of rest. Change leverage or elevation before you add load.
Common Hip Raise (bent Knee) Mistakes
Adding reps forever instead of making the movement harder
Change leverage, elevation, or tempo once you clear your rep range.
Chasing rep count until the lower back arches away
End the set at the first rep where the ribcage flares, not at failure.
Training every set to failure this early
Leave two or three reps in the tank and add sets instead.
Easier and Harder Than Hip Raise (bent Knee)
Swap Hip Raise (bent Knee) For
Hip Raise (bent Knee) — Frequently Asked Questions
How do you do the Hip Raise (bent Knee)?
Lie flat on your back with your knees bent and feet flat on the ground. Place your hands by your sides, palms facing down. Engage your core and glutes, then lift your hips off the ground until your body forms a straight line from your knees to your shoulders. Use your bodyweight only and keep the movement controlled through the full range. The animated GIF above shows the complete rep at normal speed.
What muscles does the Hip Raise (bent Knee) work?
The Hip Raise (bent Knee) primarily targets the abs. It is classified as a core exercise and is performed with your bodyweight only.
How many sets and reps of the Hip Raise (bent Knee) should I do?
For muscle growth: 3 sets of 10-15 reps with 60-90 seconds of rest. Add reps first, then slow the lowering phase. Adjust the load rather than the rep target if form breaks down before the final rep.
Is the Hip Raise (bent Knee) good for beginners?
Yes. The Hip Raise (bent Knee) is a beginner-level movement, so it is a reasonable place to start. Keep the load light enough that you can control every rep and stop 2-3 reps short of failure while you learn the pattern.
What can I do instead of the Hip Raise (bent Knee)?
Try the Dumbbell Side Bend, Sledge Hammer or the Band Standing Crunch. Each trains the abs with a similar movement pattern, so you can swap based on the equipment you have available.
