Barbell Full Squat (side POV)
Use heavy bilateral barbell loading to build control through the whole range: Barbell Full Squat (side POV) fits into any lower-body session.
How to do Barbell Full Squat (side POV)
- Stand with your feet shoulder-width apart, toes slightly turned out.
- Hold the barbell across your upper back, resting it on your traps or rear delts.
- Engage your core and keep your chest up as you begin to lower your body down.
- Bend at the knees and hips, pushing your hips back and down as if sitting into a chair.
- Lower your body until your thighs are parallel to the ground or slightly below.
- Keep your knees in line with your toes and your weight in your heels.
- Drive through your heels to stand back up, extending your hips and knees.
- Repeat for the desired number of repetitions.
Barbell Full Squat (side POV) Sets and Reps by Goal
Strength
5 sets of 2-4 reps with 3-5 minutes of rest. Keep a rep or two in reserve on the heaviest sets.
Hypertrophy
4-5 sets of 6-10 reps with 60-90 seconds of rest. Reset the bar between reps rather than bouncing.
Endurance
3-4 sets of 18-25 reps with 30-45 seconds of rest. Take the smallest plate jump available once the reps are clean.
Common Barbell Full Squat (side POV) Mistakes
Loading the bar unevenly or skipping the collars
Match the plates side to side and clip collars on every set.
Letting a nearby joint take over as the set gets hard
Stop the set as soon as the working joint stops leading the movement.
Easier and Harder Than Barbell Full Squat (side POV)
Swap Barbell Full Squat (side POV) For
Barbell Full Squat (side POV) — Frequently Asked Questions
How do you do the Barbell Full Squat (side POV)?
Stand with your feet shoulder-width apart, toes slightly turned out. Hold the barbell across your upper back, resting it on your traps or rear delts. Engage your core and keep your chest up as you begin to lower your body down. Use a barbell and keep the movement controlled through the full range. The animated GIF above shows the complete rep at normal speed.
What muscles does the Barbell Full Squat (side POV) work?
The Barbell Full Squat (side POV) primarily targets the glutes. It is classified as a legs exercise and is performed with a barbell.
How many sets and reps of the Barbell Full Squat (side POV) should I do?
For muscle growth: 4-5 sets of 6-10 reps with 60-90 seconds of rest. Reset the bar between reps rather than bouncing. Adjust the load rather than the rep target if form breaks down before the final rep.
Is the Barbell Full Squat (side POV) good for beginners?
Not usually. The Barbell Full Squat (side POV) is an advanced movement that assumes existing strength and joint control. Build up through easier legs progressions first, then add this once the basics feel comfortable.
What can I do instead of the Barbell Full Squat (side POV)?
Try the Dumbbell One Arm Snatch, Resistance Band Hip Thrusts On Knees (female) or the Sled 45° Leg Press (back POV). Each trains the glutes with a similar movement pattern, so you can swap based on the equipment you have available.
